For all of the computing power the nano has it likely wont be able to run a project like annie I had to remove it .the bo1 has issues for starters it wont load ros I have installed ros 20 times prior to this board not an issue .but this model no . It wont set up the keys for whatever reason . I'm going to attempt again today . This may go on Annie's base at some point but not back in it just too many issues.
For all of the computing power the nano has it likely wont be able to run a project like annie I had to remove it .the bo1 has issues for starters it wont load ros I have installed ros 20 times prior to this board not an issue .but this model no . It wont set up the keys for whatever reason . I'm going to attempt again today . This may go on Annie's base at some point but not back in it just too many issues.
More likely a version or configuration issue... sometimes these thing's occur!
Let us know how you go 😉
@frogandtoad yes you are correct the b01 takes a little more configuration than the original nano it isn't off annie I just took it out of the inside mount I'll move it down to the base for easier access and closer to the tf mini.the raspberry pi 3b+is an absolute solid board for this just like the panda these boards are highly reliable and in my opinion just as capable especially now with all that is available for it I even found a sd card image you can flash that is already running kenetic from ubiquityrobotics cool and good people over there .also if you haven't already check out pi apps it works awesome with pi 3 4 .😁👍🏕
I even found a sd card image you can flash that is already running kenetic from ubiquityrobotics cool and good people over there .also if you haven't already check out pi apps it works awesome with pi 3 4 .
Thanks for the tip... will check it out some time.