Notifications
Clear all
Topic starter
2021-07-27 3:27 pm
When it comes to the CH340 instead of FT232RL, is there any reason to avoid the NANO using the CH340? Just curious before I buy any as I am only slightly familiar with the UNO.
Thanks
Voltage
Thanks,
Voltage
2021-07-27 3:50 pm
I have never had a problem with them. I get the Elegoo 3 pack. They are cheap but you have to solder on the pin headers. I have also been very happy with all their other products too. Good clones.
It's a lot like the Uno. Just plug in the USB and upload. Easy to work with. Just make sure you have a Mini-B USB cable.
Voltage reacted
2021-07-27 4:01 pm
Some people used to have problems getting the right driver, but I haven't heard many complaints about that lately.
Anything seems possible when you don't know what you're talking about.
Voltage reacted
Topic starter
2021-07-27 5:29 pm
I have never had a problem with them. I get the Elegoo 3 pack. They are cheap but you have to solder on the pin headers. I have also been very happy with all their other products too. Good clones.
It's a lot like the Uno. Just plug in the USB and upload. Easy to work with. Just make sure you have a Mini-B USB cable.
Thanks madmisha. I was looking at the 3 pack from the LAFVIN store on Amazon. I will look at the Elegoo and compare.
The LAFVIN ones have the upgraded CH340G chip.
Thanks,
Voltage
Topic starter
2021-07-27 5:30 pm
Some people used to have problems getting the right driver, but I haven't heard many complaints about that lately.
Thanks will, that's good to know.
Thanks,
Voltage