<?xml version="1.0" encoding="UTF-8"?>        <rss version="2.0"
             xmlns:atom="http://www.w3.org/2005/Atom"
             xmlns:dc="http://purl.org/dc/elements/1.1/"
             xmlns:sy="http://purl.org/rss/1.0/modules/syndication/"
             xmlns:admin="http://webns.net/mvcb/"
             xmlns:rdf="http://www.w3.org/1999/02/22-rdf-syntax-ns#"
             xmlns:content="http://purl.org/rss/1.0/modules/content/">
        <channel>
            <title>
									New PCB with ATMEGA328P - Arduino				            </title>
            <link>https://forum.dronebotworkshop.com/arduino/new-pcb-with-atmega328p/</link>
            <description>Discussion board for Robotics, Arduino, Raspberry Pi and other DIY electronics and modules. Join us today!</description>
            <language>en-US</language>
            <lastBuildDate>Thu, 12 Nov 2026 20:08:42 +0000</lastBuildDate>
            <generator>wpForo</generator>
            <ttl>60</ttl>
							                    <item>
                        <title>New PCB with ATMEGA328P</title>
                        <link>https://forum.dronebotworkshop.com/arduino/new-pcb-with-atmega328p/#post-23443</link>
                        <pubDate>Thu, 23 Dec 2021 00:12:10 +0000</pubDate>
                        <description><![CDATA[Hi,
I designed open firmware board with ATMEGA328P-AN, made a new Arduino shield using Rx,Tx, GND and RESET pins via a cable in order to programming the ATMEGA328P-AN. I removed the ATMEGA3...]]></description>
                        <content:encoded><![CDATA[<p>Hi,</p>
<p>I designed open firmware board with ATMEGA328P-AN, made a new Arduino shield using Rx,Tx, GND and RESET pins via a cable in order to programming the ATMEGA328P-AN. I removed the ATMEGA328P chip from the original board and tried to download sketch into external PCB. After countless programming attempts, Googled in order to see the problem. I found few articles, if I understand need to download bootloader into external ATMEGA328P-AN, then Arduino IDE should download the sketches.  But the PCB manufactured, I wasn't aware that need ICSP connector on the PCB. Now is there an option to download the bootloader via Tx,Rx of the serial UART?</p>
<p>Thank you, </p>]]></content:encoded>
						                            <category domain="https://forum.dronebotworkshop.com/arduino/">Arduino</category>                        <dc:creator>rodrik5000</dc:creator>
                        <guid isPermaLink="true">https://forum.dronebotworkshop.com/arduino/new-pcb-with-atmega328p/#post-23443</guid>
                    </item>
							        </channel>
        </rss>
		