triform
triform
@triform
Member
Joined: 2019-07-17 2:09 am
Last seen: 2023-03-21 4:56 pm
Topics: 34 / Replies: 290
Reply
3 years ago
Forum
Reply
RE: Arduino IoT Cloud 2021 - Getting Started with Arduino & ESP32

Sorry, no help from me then as I tend to use Node-Red mostly now. Others may have info here as well as the IoT section at/p>

3 years ago
Forum
Reply
RE: Arduino IoT Cloud 2021 - Getting Started with Arduino & ESP32

We will need more data here :) What IoT service are you using? What are you trying to set up?

3 years ago
Forum
Reply
RE: RPI Pico ESP-01 breakout board (Updated)

I have an updated Gerber for an RPI-Pico breakout board free for the making. It includes a place for an ESP-01 module, power for the Pico a...

3 years ago
Forum
Topic
Forum
Replies: 0
Views: 1407
Topic
Forum
Replies: 3
Views: 987
Reply
RE: Mechanical Bumpers for Robot base

@thrandell Unfortunately, this rarely happens :( The wheels almost always turn. For smaller bots, this usually makes it skew the current path...

3 years ago
Topic
3 years ago
Forum
Replies: 0
Views: 1246
Reply
RE: Switch AC motors on and off with Arduino

@mike-za, I would try and source the control board outside the vendor. Unless it's some soviet made oddity from the cold war era, you should be able...

4 years ago
Reply
RE: MD10C Question

@huckohio The MD10C may not be grounded well. Is this seen on both controllers or just the one? A floating ground can cause induced noise and again,...

4 years ago
Reply
RE: MD10C Question

@huckohio It could be caused by a lot of things. Inductance, leakage, etc. Having a lot of wires running around, you can transfer or pickup voltage ...

4 years ago
Reply
RE: Using a POT to control PID values

@byron I think a pot would be a better choice here. Less stuff to do in the code. Just a map and constrain pair with the analog value.

4 years ago
Reply
RE: USING A CAMERA ON RASPBERRY PI WITHOUT MOTIONEYEOS

Hi @peterpenpencil, I'm not sure if I understand what you really want, but this is what I have used on the RPI and Yun to stream with: ffmpeg Scot...

4 years ago
Reply
RE: High quality Equipment and where to get it

Hi @wolfgangw, I agree with the premise of the idea and have a set of sellers I try to use and recommend, but there are issues even with this many t...

4 years ago
Reply
RE: Using IR to count a bike wheel rotation, then map to tone for speaker.

Hi @mc2, How are you controlling the speaker? I would assume through a gpio pin, correct? If that's the case then you could use a PWM IO pin and ma...

4 years ago
Forum
Page 1 / 22