@roodyj Jim, Thanks for getting back. I didn't even know there was a "Tutorial." My O/S is Windows 10 and I have set up the stepper as an AP rather t...

@roodyj Hi Jim, Awesome! Now, this may seem like an "odd" question, but how did you set it up as a "station?" Good evening from Texas, Juha

@roodyj Jim, BINGO - Increased PWM frequency to about 40 kHz and played with Kt etc. values. No "stall flag" or any other flag for that matter :-)! J...

@roodyj Jim, Managed to connect to the controller using an "ancient" lap-top, but I still need to be able to do that on another, more conveniently lo...

@roodyj Jim, Did you have issues with lap-top or desk-top when connecting to the controller over Wi-Fi? I still can't do it and must connect using my...

@roodyj Screen-capture didn't pan out, but am sending settings (Servo in Voltage Control mode) here. See attached Word document. Again, I am getting...

@spyder No worries :-)!

@spyder The DC portion of the cable isn't very long, the rest is AC. And, the same extension cord I use on my hedger without any problems. Also, the...

@roodyj Jim, The stepper works quite well in that I am able to tune a mag loop antenna. The only issue is the "Stall flags." Just need to adjust par...

@byron Hi Byron, I am using the Good Robotics platform and the Drone Bot video was very helpful in orded to get up and running. As I wrote in another...

@roodyj Jim, Yes, I am using the GR controller. To issue commands I use my Android smartphone as my lap-top is dedicated to processing of audio in th...

@roodyj Hi Jim, I sure appreciate the come-back. I have made some adjustments to parameters. Still get a Stall flag, but no over-current flag. Som...

Hello "Altoidian," Thanks for come-back. I used the link to the motor that the maker of the platform emailed, but it doesn't return any results any m...