@josiah430 Are you using a charging cable or data cable? If I use the wrong cable the PC will not recognize my ESP32.

@Zander I purchased the NEXTION INTELLIGENT SERIES because it provides more setting/programming options. I found the Nextion editor a little bug...

@Zander I did make that request last year but never heard back.

@Zander Sorry Ron, my one and old experience with using HMI displays in the NEXTION. If you are only using it for testing, then I see some of th...

@zander I'll look for the reference. It may be from the ESP32-S3 documentation on declaring serial ports (the extra arguments). Just to be sur...

@Zander I am sure the examples ARE coded correctly (for the vision of the developer at the time), unless you need to assign the RX & TX pins ...

This is from the declaration section of the code : EasyNex myNex(Serial2);

@zander Ron, here is the line from the library that I commented out: //_serial->begin(baud); // We pass the initialization data to the obje...

@rebeljd I would make it clear that this LL refers to using the ESP32 with the Easy Nextion Library. My only issue was getting Serial2 to work. O...

@zander One more thing...I did sent an email to the library owner asking to change the library to allowed to assigning serial port pins in the libr...

Forgot the link:

@zander Ron, I also had to comment out a line in the EasyNextionLibrary for my project I documented last fall. This is from my project post: I...

@rebeljd This is the ESP32 I used. ESP32-S3-DevKitC-1-N8R2 Development Board

@rebeljd KeeYees 10pcs 4 Channels IIC I2C Logic Level Converter Bi-Directional Module 3.3V to 5V Shifter for Arduino (Pack of 10)

@rebeljd Forgot to address the 5V. The 5V signal line you see is providing 5V to both the logic level converter "high side" and to the nextion d...