Last seen: 2022-05-07 11:37 pm
Thank you I will
I agree but since I'm using what has been said is a working sketch and since my knowledge of arduinos is very limited I figured that maybe a differen...
Hello Everyone I'm sorry for getting back to everyone late I'm working on a lot of projects at once. Ok I hooked up a new board an Elegoo 2560 and ran...
@eliza Thank you Eliza I will try them in the morning.
@zander I did upload it that other picture is the screen monitor of it running
@eliza Hi Eliza I tried to run your sketch and here's what I saw I also ran this on both arduinos.
@eliza Hi Eliza I'm trying to run your program and I'm getting multiple faults when I try to verify it before loading it into the boards?
@inst-tech Thank you for concern and I agree safety is paramount I'm trying to use all of original safety controls in these circuits and since they ar...
@eliza So how the digi-sensor operates is when moving the joy stick in any direction it powers the digi-sensor with 12 volt input then the output is o...
I thank you for your concerns and trust me I'm painfully aware of safety. But the fact that the lift is going to be using all the original controls an...
@eliza I have controlled the lights and also relays and as far as the joysticks that's a little harder my machine has a device known as a digi-sensor ...
@robotbuilder I do have the schematics and manual for the lift and actually none of the safety devices have to be disabled. Since the machine was desi...
Hi thank you Eliza because its spring here I'm doing a lot of projects outside as well. Unfortunately I'm not that up to speed with these Arduinos I j...
Hi Guys sorry I'm late getting back to everyone I have limited time to try fix this stuff. I tried to change out both of antennas and adapters I bough...
@eliza Hi Eliza thanks for taking the time to answer me. I'm trying to get the two boards to communicate with each other its not for this project I'm ...