Centari
Centari
@centari
Member
Joined: 2020-01-08 2:07 pm
Last seen: 2021-10-19 2:22 pm
Topics: 1 / Replies: 43
Reply
RE: Other Robot Projects

Looks good, though I would use a slightly higher voltage to charge the batteries fully, and a charge controller to ensure full charge / prevent overch...

3 years ago
Reply
RE: Elego breadboard power supply only providing 4.96V

@yurkshirelad Just female pin headers, same as you'd use on an Arduino, or esp8266, etc. Single inline pins, 5 pins long in my case. Number of pins a...

3 years ago
Reply
RE: Elego breadboard power supply only providing 4.96V

Couldn't sleep...... looks like it only took 3 hours. :) I'll look up the part numbers for the fuse holder clips if you'd like. I used a random ...

3 years ago
Reply
RE: Elego breadboard power supply only providing 4.96V

@yurkshirelad I'll get on it. It shouldn't take but a couple days at most. You could do just the 5v and 3.3v regulators, but you'll have more heat in ...

3 years ago
Reply
RE: Elego breadboard power supply only providing 4.96V

I have found those power supplies to be a load of crap for the most part. I got a group of 5, as they were near the same price as one when shipping wa...

3 years ago
Reply
RE: Question about if they make 2mm RGB LEDs

If you can go with SMD, there are several options on Digi-Key. Nothing in through-hole was smaller than 3mm on both Digi-Key, and Mouser. On Digi-Key,...

3 years ago
Reply
RE: Identifying code loaded on Arduino

@ozcraig, I've gotten to where I always start the serial routine and have it pass the program name back to the terminal. The name I saved the program...

3 years ago
Forum
Reply
RE: RC car takeover

I have not built a robot yet, but have put considerable thought to it so far. I still think drive and avoidance sensors should be on a micro controll...

3 years ago
Forum
Reply
RE: I lost a couple hours to an oddity, thought I'd pass on a heads up.

sorry for the crap pictures..... Cheap tester from E-Bay, does transistors, capacitors, inductors, and such.

3 years ago
Reply
RE: RC car takeover

I would not rule out an inexpensive Arduino for the basic controls. Then control that with your AI system. If wires get crossed in assembly or a crash...

3 years ago
Forum
Reply
RE: Soldering stations for beginners?

@yurkshirelad, I would recommend what I use, if it was still made..... Anyway, whatever you end up getting, make sure you can change the temperature...

3 years ago
Forum
Reply
RE: I lost a couple hours to an oddity, thought I'd pass on a heads up.

I tested half of the 100 I have, all were the same, which makes sense. They are produced in batches, then sold in bunches from the batches. If you ch...

3 years ago
Reply
RE: Measuring Temperature with Arduino - 5 Sensors

@mbogelund Same here with firefox and mint. It appears to be placeholders for the code that was supposed to accompany the article.

3 years ago
Forum
Reply
RE: News from RoboPi's Sister

Prayer sent. Best wishes for a complete recovery.

3 years ago
Page 1 / 3