borkutip
@borkutip
Member
Joined: 2021-04-19 11:18 am
Last seen: 2021-04-22 9:33 pm
Topics: 1 / Replies: 5
Reply
RE: Arduino (as signal generator) to ADS1115 to Raspberry Pi (using FFT to evaluate frequency)

Hi Jim, This is a very interesting project. I am afraid that I can not write anything usable, because I did not do anything similar to this, but I f...

3 years ago
Forum
Reply
RE: L298N right driver to use.

Hi Greg, Yes, it is capable. It can provide 2 amps (at maximum) per motor (probably with only appropriate cooling). See the specs: Fig 6 shows, ...

3 years ago
Forum
Reply
RE: L298N right driver to use.

Hello, You have not mentioned the type of your motor, I assume, that you have two DC motors. Yes, L298 is capable of driving independently two...

3 years ago
Forum
Reply
RE: Actuating 2 steppers

Hello,Here is a theoretical algorithm, I do not know if it suits you:Let's say Motor1 needs N steps and Motor2 needs K steps and the time for going al...

3 years ago
Forum
Reply
RE: ATX based power supply. Need to vary output voltage on the 12 volt line.

Hello, for a buck-boost converter I ordered this from Aliexpress:(ZK-4KX). It works for me, connected to an old ATX power supply. I ordered another ...

3 years ago
Topic
Replies: 0
Views: 496