Last seen: 2019-12-01 7:15 pm
@pugwash Thanks Pugwash, All good points. I will keep progressing with the mechanical part assemble. When I reach a point where I can test some of o...
@pugwash Hello Pugwash, thank you for your insightful input. You are correct....many of the variables of the design are unknown. So I decided to sta...
Here is a copy of the current sketch code. Keep in mind, I am new to this, so I'm sure it is very flawed in nature. It did compile. // defines pins nu...
@pugwash OK, Pugwash... I will give one more try. I was able to cobble together enough Arduino code through plagiarism to make a rough start at tryin...
@dronebot-workshop Hello Bill, I don't see a method to remove a post. Would you please remove this post "Magmov Generator (Need Sketch Program Help)"...
@robo-pi Thanks for the advice. Still leaves me in search of programming assistance, but I understand your reluctance.
This a test on how to apply photos. For anyone else viewing this....just drag a JPG format file into the comment section. Then at the bottom of thi...
@spyder Thanks for kind welcome. I am still learning how to interact in this forum. I will do allot of reading initially....then maybe suggest a few ...